Stenograph LUMINEX - Page 88

80
2019 Stenograph, L.L.C. All Rights Reserved.
80
Luminex Users Guide
Chapter 3 Writing on the Luminex
were held down and when they were released. This information may help you make better key
adjustments, if necessary and understand your writing style better. It also may help when editing in
Case CATalyst to determine misstrokes.
By default, the Luminex writes TrueStroke data, the.sgxr2 subfile, to the Data SD card along with the
steno note file. When you read the steno note file into Case CATalyst 10.07 or higher, the TrueStroke
data is automatically copied to the job subfile, Steno X-ray2. When writing realtime via the micro USB
cable or WiFi connection, the TrueStroke data is written to Data SD card and the Case CATalyst job
subfile, Steno X-ray2. Note: Case CATalyst V13 or higher is required for a WiFi connection.
To view TrueStroke information in Case CATalyst, display the vertical notes for the realtime job and
double click the steno outline for the TrueStroke data you want to view. See the Case CATalyst Help
more information about TrueStroke data. The free, downloadable TrueView® utility allows Case
CATalyst V10.06 or earlier versions and other CAT software users to view the TrueStroke data for
steno files. This may be helpful if you are student or just getting started as a reporter.
To change the TrueStroke setting:
1. From the Opening Menu, touch Setup, More, Options.
2. Use the Down/ Up sensors to highlight the Save TrueStroke Files to Data SD card option.
3. Touch Change to select Yes or No.
· Yes - saves the TrueStroke Data to the Data SD Card.
· No - does not save the TrueStroke Data to the Data SD Card.
4. To display the Opening menu, touch OK, More, Quit.