Shanghai STEP Electric Corporation
door. Press the up and down button to browse the front door open allowed parameter of
corresponding floor. Press the enter button to make modification. The figure in the lowest order
starts to flash, use up or down button to modify the figure into 0 or 1. Press the enter button to
confirm the modification (0 is to shield front door open allowed function, 1 is to allow front door
open function)
Login authorization is required for the front door open allowed modification, Once modify
parameter and press the enter button in non login stat, login menu will pop up.
18 rear door open allowed
Door open allowed or not
Floor
Rear door
The above picture mean: shield 1 floor rear door open allowed. Rd is the abbreviation of rear door.
Press the up and down button to browse the rear door open allowed parameter of corresponding
floor. Press the enter button to make modification. The figure in the lowest order starts to flash,
use up or down button to modify the figure into 0 or 1. Press the enter button to confirm the
modification (0 is to shield rear door open allowed function, 1 is to allow rear door open function)
Login authorization is required for the rear door open allowed modification, Once modify
parameter and press the enter button in non login stat, login menu will pop up.
19 control parameter reset
The menu realizes the reset of control parameter F0-F199. Please note the control parameter reset
is only valid when the login level is equal or more than the level-2. There is no use to press enter
button if the login level is not qualified. Once the login qualification is met, press the enter button
to enter into the menu for the authentication code input (the authentication code setting is against
the misoperation. The authentication code always is 5678) if the authentication code is right, press
the enter button and control parameter reset.
20 drive parameter reset
To Next Page
Loading...
Need help?
General
