6 — Operation
45
10085896_H
V-PRO
®
maX 2
Operator Manual
Sterilization Cycle can be aborted any time during normal unit operation. If a cycle is aborted, the load must be
repackaged and reprocessed.
NOTE: For Control Display touch panel screen touch pad definitions, refer to Symbols.
To abort the VHP Sterilization Cycle in progress, see below.
NOTE: For Control Display touch panel
screen touch pad definitions, refer to
Symbols.
This screen allows operator a final chance to
continue with current cycle in progress instead of
aborting cycle operation.
Press
YES
. Printer records time cycle was
aborted. ABORT screen is displayed.
NOTE: For an Aborted Cycle, note the
following:
1) If the cycle is aborted before the
Sterilization phase, the control
system safely relieves chamber
vacuum before allowing opening of
the chamber door. If the cycle is
aborted during or after Sterilization
phase, a complete Aeration phase is
performed.
2)Press lower right touch pad to silence
alarm.
*
DANGER – CHEMICAL INJURY HAZARD: Any visible liquids in the chamber or on the load must be treated as concentrated
hydrogen peroxide. Observe all hydrogen peroxide handling precautions. Refer to the VAPROX HC Sterilant Safety Data Sheet
(SDS) for appropriate Personal Protective Equipment (PPE; refer to Glossary), spill containment and cleanup.
When Abort phase is complete, ABORT Complete
screen is displayed.
Pressing
Back Arrow
touch pad (lower left)
returns CYCLE (or Ready) screen to control display.
*
1. Press Abort touch pad (inverted red triangle) on OPERATING screen. This screen allows operator a final chance to
continue with current Cycle in progress instead of aborting cycle operation.
2. Press Yes. Printer records time cycle was aborted. ABORT screen is displayed.
To Next Page
Loading...
