Service Information
71
ZOOMR OPTION DC MOTOR BOARD REMOVAL AND REPLACEMENT
Required Tools:
Phillips Screwdriver 1/8” Allen Wrench Bungee Cords
T27 Torx
Procedure:
1. Raise the litter to the full up position.
2. Unplug the power cord from the wall socket and push the battery power on/off switch to the “OFF” posi-
tion.
3. Using a Phillips screwdriver, remove the four screws holding the base hood to the base frame.
4. Open the cable clamp at the head end, left side of the base frame and remove the cables from the clamp.
5. Lift the base hood and support it from the litter frame using bungee cords or the equivalent.
6. Using a T27 Torx, remove the four screws holding the cover to the side of the electronics box.
7. Properly ground yourself (see page 39 for static discharge precautions).
8. Using a 1/8” Allen wrench, remove the four bolts and standoffs holding the motor board to the electronics
box.
9. Remove all cables from the motor board and remove the board.
NOTE
Note the locations of the cables so you can connect them properly to the new motor board.
10. Reverse steps 1 − 8 to install the new power board.
To Next Page
Loading...
Need help?
General
