Maintenance Procedures − Siderail
94
SIDERAIL ASSEMBLY REMOVAL
Required Tools:
T27 Torx
Removal Procedure:
1. Run the head section up electrically when removing a head end siderail.
2. Unplug the bed power cord from the wall socket.
3. Lower the siderail being removed.
NOTE
If removing a head end siderail, the cable must be unplugged.
A
B
4. Using a T27 Torx, remove the screw from the ground strap and the two screws (A − head end) or (B −
foot end) holding the complete siderail assembly on the head or foot section.
5. Push in on the siderail assembly to clear under the head or foot section and pull the siderail back to re-
move it from the bed.
6. Reverse the above steps to reinstall the siderail assembly.
NOTE
Grease the glide rods on the replacement siderail assembly with Syntech grease.
To Next Page
Loading...
Need help?
General
