Index-4 SPARCclassic/SPARCclassic X/SPARCstation LX Service Manual • November 1993
requirements
environmental, A-2
input power, A-1
S
safety precautions (table), 10-3
SBus
boards, 1-5
cards, 1-5
options, 1-6
printer board, 1-6
slots, 1-5
SCSI
disconnecting, cable, 7-1
factory address setting, 9-4
ID jumper location, 9-4
verifying a defective controller, 4-6
serial cable, 3-5
speaker, replacing, 8-4, 8-6
specifications, physical, A-3
SunDiagnostic Executive, 2-10
system
abnormal response, 6-3
closing, 7-4
differences, 1-2
front panel, 1-1
I/O board
removing
replacing, 8-12
opening, 7-2
rear panel, 1-1
subassembly access, 7-1
system components, 1-1
system I/O board
location, 8-7
removing, 8-7
system overviews
SPARCclassic, 1-1
SPARCclassic X, 1-1
SPARCstation LX, 1-1
system power supply, location, 8-1
T
test, C-3
MLB, 4-5
power supply, 4-3
test points, 11-18
test<device path>, C-3
test-all, C-3, C-4
test-memory, C-7
thick Ethernet, C-5
tip, 3-5
tip window, 3-5
tools needed to replace CRUs, 5-3
troubleshooting, 2-1
turning off power, 6-2, 6-4
twisted pair Ethernet (TPE), C-5
U
unit illustration
bottom, 12-3
top, 12-2
V
video connectors, See connectors
video display resolutions, 1-5
Video Frame Capture Board, 1-6
video output, none, 4-2
video single in-line memory module (VSIMM), See
VSIMM
VSIMM
installing, 11-9
resolutions supported, 1-5
W
watch-aui, C-4
watch-clock, C-4
watch-net, C-4
watch-net-all, C-4
watch-tpe, C-4
wrist strap
attaching, 7-4
detaching, 7-4
To Previous Page
Loading...
Need help?
General
