Sun Microsystems SPARC classic - Safety and Tools Requirements; Safety Requirements

5-1
CHAPTER
5
Safety and Tools Requirements
This chapter describes standards, safety procedures, and precautions you should
follow whenever you need to replace or remove assemblies or subassemblies from
your system.
■ Section 5.1 “Safety Requirements”
■ Section 5.2 “Symbols”
■ Section 5.3 “System Precautions”
■ Section 5.4 “Tools Required”
5.1 Safety Requirements
For your protection, observe the following safety requirements:
■ Follow all cautions, warnings, and instructions marked on the equipment.
■ Ensure that the voltage and frequency rating of the power outlet to be used
matches the electrical rating labels on the system.
■ Use properly grounded power outlets.