CHAPTER 9
MBus Modules
If you remove a defective MBus module, install the replacement MBus module in the
same slot.
Tools Needed
To remove and install an MBus module you need the following tools and materials:
4
Phillips screwdriver (size #2)
4
Card extractor
4
Wrist strap
4
Antistatic surface
Removing the MBus Module
1. Power off the system and disconnect the expansion units.
Refer to Chapter 4.
Caution - Printed circuit boards are made of delicate electronic components that are
extremely sensitive to static electricity. Ordinary amounts of static from your clothes
or work environment can destroy the boards.
97
To Next Page
Loading...
