CHAPTER 7
Non-Volatile RAM (NVRAM)
This chapter explains how to remove and install a Non-Volatile RAM (NVRAM)
from the SPARCstation 10 system.
Tools Needed
To remove and install the NVRAM, you need the following tools and materials:
4
Phillips screwdriver (size #1)
4
Phillips screwdriver (size #2)
4
Wrist strap
4
Antistatic surface
4
Card extractor
Removing the NVRAM
Power off the system and disconnect the expansion units (refer to Chapter 4).
Caution - Printed circuit boards are made of delicate electronic components that are
extremely sensitive to static electricity. Ordinary amounts of static from your clothes
or work environment can destroy the boards.
81
To Next Page
Loading...
