CHAPTER 16
Light-Emitting Diode
This chapter explains how to remove and install the light-emitting diode (LED).
Tools Needed
To remove and install the LED you will need the following tools and materials:
4
Phillips screwdriver (size #2)
4
Wrist strap
4
Antistatic surface
Removing the LED
Follow the instructions in Chapter 4 to power off the system and disconnect the
expansion units.
Caution - The hard disk drive contains electronic components that are extremely
sensitive to static electricity. Ordinary amounts of static from your clothes or work
environment can destroy the components.
Wear a grounding strap when handling the drive. Refer to “Attaching the Wrist
Strap” on page 34 in Chapter 4. Do not touch the components or any metal parts.
161
To Next Page
Loading...
