CHAPTER 17
Powering On the System
This chapter explains the steps to perform before and after replacing a part. Unwrap
the wrist strap from your wrist and detach the adhesive copper strip from the power
supply. Topics covered in this chapter include the following:
4
Installing the system unit cover
4
Connecting peripheral(s) to the system
4
Turning the power on
Installing the System Unit Cover
Note - The card retainers on the MBus module should be pushed down over the edge
of the module. You will not be able to close the system unit cover properly otherwise.
To install the system unit cover:
1. Hold the cover at an angle, approximately as shown, and gently guide the
hinge tabs on the cover into the tab slots on the front of the system unit.
Continue to hold onto the cover.
See Figure 17–1.
169
To Next Page
Loading...
