Sun Microsystems SPARCstation 10 - DSIMM Insertion Tool

Note - Slot J0201 must always have a DSIMM installed in order for the system to
function properly. In any SPARCstation 10 system, it is the first slot to be filled
with a DSIMM. Each additional DSIMM should be installed in the sequence
shown in Table 5–3.
TABLE 5–3 DSIMM Installation Sequence
Installation Sequence Slot
1 J0201
2 J0304
3 J0203
4 J0302
5 J0303
6 J0301
7 J0305
8 J0202
DSIMM Insertion Tool
If your system did not come with a DSIMM Insertion Tool, press the DSIMM into
place with your fingers.
1. Identify the insertion tool and its two surfaces.
See Figure 5–36 and Figure 5–37.
68
SPARCstation 10 Service Manual ♦ Revision A, July 1993