CHAPTER 11
Power Supply Assembly
This chapter describes how to remove and install the power supply assembly. The
power supply assembly also contains fans.
Tools Needed
To remove and install the power supply assembly you need the following tools and
materials:
4
Phillips screwdriver (size #2)
Caution - Make sure to disconnect the power cord from the back panel of the
system unit before removing the power supply assembly from the system unit.
Removing the Power Supply Assembly
1. Power off the system and disconnect the expansion units. Refer to Chapter 4.
2. Turn the power switch off (O) position.
3. Check that the green LED at the front of the chassis is not lit.
4. Remove the power cord from the system unit.
115
To Next Page
Loading...
