4
Card extractor
4
Chip extractor
4
Needle nose pliers
4
Volt-Ohmmeter (VOM) for checking voltages and continuity
Antistatic Surface
Place static-sensitive parts such as boards, cards, modules, and SIMMs on an
antistatic surface. The replacement procedures notify you when to place a part on an
antistatic surface. The following items can be used as an antistatic surface:
4
Bag that is used to wrap a Sun replacement part.
4
Shipping container that is used to package a Sun replacement part.
4
Inner surface of the system unit cover.
4
Sun ESD mat with Sun logo. Available for purchase through your Sun sales
representative.
4
Disposable ESD mat. Available for purchase through your Sun sales representative.
Disconnecting External SCSI Peripherals
If your system unit has external SCSI peripherals connected to it, disconnect the SCSI
connector from the back of the system unit.
1. Press the finger clips on the SCSI connector.
2. Pull the connector to disconnect.
This action disconnects the SCSI cable from the system unit.
Removing the System Unit Cover
You need a Phillips screwdriver size #2 to remove the cover from the system unit.
32
SPARCstation 10 Service Manual ♦ Revision A, July 1993
To Next Page
Loading...
