CHAPTER 14
DC Power Harness
This chapter explains how to remove and install the DC power harness for a
SPARCstation 10 system.
Tools Needed
To remove and install the DC power harness you will need the following tools and
materials:
4
Phillips screwdriver (size #2)
4
Wrist strap
4
Antistatic surface
Removing the DC Power Harness
Power off the system and disconnect the expansion units. Refer to Chapter 4.
Caution - The hard disk drive contains electronic components that are extremely
sensitive to static electricity. Ordinary amounts of static from your clothes or work
environment can destroy the components.
141
To Next Page
Loading...
