To remove the diskette drive from the system:
1. Check that the green LED at the front of the chassis is not lit.
2. Check that the system power cord remains connected to the system and the
wall outlet.
3. Remove the system unit cover.
Refer to “Removing the System Unit Cover” on page 32 in Chapter 4.
4. Attach the wrist strap.
Refer to “Attaching the Wrist Strap” on page 34 in Chapter 4.
5. Remove both clips from the diskette drive mounts before you remove the
diskette drive. Keep the clips for future use.
See Figure 13–1.
Figure 13–1 Removing Diskette Drive Clips
6. Slide the diskette drive toward the outer side of the chassis to free the
grommets from the drive mounts.
See Figure 13–2.
136
SPARCstation 10 Service Manual ♦ Revision A, July 1993
To Next Page
Loading...
