xii Sun Fire T2000 Server Service Manual • July 2007
FIGURE 4-5 Replacing the Blower Unit 4–8
FIGURE 4-6 Locating the Hard Drive Release Button and Latch 4–10
FIGURE 5-1 Slide Release Latches 5–4
FIGURE 5-2 Locating the Metal Lever 5–5
FIGURE 5-3 Top Cover and Release Button 5–7
FIGURE 5-4 Removing the Front Bezel From the Server Chassis 5–8
FIGURE 5-5 Location of PCI-Express and PCI-X Card Slots 5–9
FIGURE 5-6 Location of PCI-Express and PCI-X Card Slots 5–10
FIGURE 5-7 PCI Card and Hold-Down Bracket 5–11
FIGURE 5-8 DIMM Locations 5–13
FIGURE 5-9 Ejecting and Removing the System Controller Card 5–18
FIGURE 5-10 Locating the System Configuration PROM 5–18
FIGURE 5-11 Motherboard Assembly 5–20
FIGURE 5-12 Cable Cutout 5–21
FIGURE 5-13 Location of the Screws in the Motherboard Assembly 5–22
FIGURE 5-14 Removing the Motherboard Assembly From the Server Chassis. 5–23
FIGURE 5-15 Installing the Motherboard Assembly 5–25
FIGURE 5-16 Securing the Motherboard Assembly to the Chassis 5–26
FIGURE 5-17 Location of Power Supply Latch 5–28
FIGURE 5-18 Location of Bus Bar Screws on the Power Distribution Board and the Motherboard
Assembly 5–29
FIGURE 5-19 Removing the Power Distribution Board 5–30
FIGURE 5-20 Installing the Power Distribution Board 5–31
FIGURE 5-21 Removing the LED Board From the Chassis 5–33
FIGURE 5-22 Removing the Fan Power Board 5–34
FIGURE 5-23 Removing the Fan Guard 5–35
FIGURE 5-24 Removing the Front I/O Board 5–36
FIGURE 5-25 Removing the SAS Disk Backplane 5–38
FIGURE 5-26 Replacing the SAS Disk Backplane 5–39
FIGURE 5-27 Removing the Battery From the System Controller 5–40
To Next Page
Loading...
Need help?
General
