Chapter 2 Setting Up XSCF 2-81
SNMPv1/
SNMPv2c
communication
Enables/disables SNMPv1 and SNMPv2c
communication.
setsnmp The community string
used to enable
SNMPv1/SNMPv2c is
Read-Only.
SNMPv3 trap Makes the following SNMPv3 trap settings:
• User name (Note 1)
• Authentication password (Note 1)
• Encryption password (Note 1)
• Engine ID of local agent or request of an
acknowledgement from the receiving host.
• Port number of the trap destination
• Host name of the trap destination
setsnmp • Must start with 0x, but
also consist of an even
number of hexadecimal
digits.
• One of the following two
authentication
algorithms is selected:
MD5, Secure Hash
Algorithm (SHA)
• The default values of the
trap destination host are
to be defined.
• The default port number
of the trap destination is
162.
SNMPv1/
SNMPv2c Trap
Makes the following SNMPv1 and SNMPv2c
trap settings:
• Trap type setting
• Community string
• Port number of the trap destination
• Host name of the trap destination
setsnmp • One of the following
three trap types is
selected: v1, v2, inform
(Note 2)
• The default port number
of the trap destination is
162.
Disable
SNMPv3 trap
Disables trap sending to the target host, with
the following specified:
• User name
• Trap destination host
setsnmp
Disable
SNMPv1/
SNMPv2c trap
Disables trap sending to the target host, with
the following specified:
• Defined protocol type (v1/v2c)
• Trap destination host
setsnmp
Initialize SNMP
configration
Stops the SNMP agent and change the
SNMP configration set by setsnmp(8) to the
default.
setsnmp
Display USM
management
information
Displays the USM management information
for the SNMP agent
showsnmpusm
TABLE 2-17 SNMP Administration (Continued)
Item Description Shell Command Remarks
To Next Page
Loading...
Need help?
General
