2-82 SPARC Enterprise Mx000 Servers XSCF User’s Guide • August 2009
Note – (1) A user name, authentication password, and encryption password that are
common to both the sending and receiving sides are set for an SNMPv3 user.
Note – (2) If inform is specified, InformRequest is sent using the SNMPv2c agent.
Setting the SNMP Agent’s System Management Information and
Enabling/Disabling the SNMP Agent
â– Command operation
1. Use the showsnmp(8) command to display the SNMP settings.
USM
management
information
Sets USM management information for the
following for the SNMP agent:
• Specifying a user authentication algorithm
• Sets authentication/encryption passwords
for users
• Changing authentication/encryption
-passwords for users
• Copying a user
• Deleting a user
setsnmpusm • SNMPv3 settings.
• Specify the password
over 8 characters.
Display VACM
management
information
Displays VACM management information
for the SNMP agent
showsnmpvacm
VACM
management
information
Sets VACM management information for the
following for the SNMP agent: Making
access control group and access control view
(MIB view) settings for a user
• Adds a user account to an access control
group
• Deleting a user from an access control
group
• Creating an MIB access control view
• Deleting an MIB access control view
• Providing an MIB access control view to a
group
• Deleting a group from all MIB access
control views
setsnmpvacm • SNMPv3 settings.
• Any access control view
that is provided to a
group is a Read-Only
view.
TABLE 2-17 SNMP Administration (Continued)
Item Description Shell Command Remarks
To Next Page
Loading...
Need help?
General
