Chapter 2 Setting Up XSCF 2-117
Deleting a System Board From a Domain
â– Command operation
1. Use the showdevices(8) command to display the usage of XSB resources.
<Example> Display usage of XSB resources of domain ID 2.
XSCF> showdevices -d 2
CPU:
----
DID XSB id state speed ecache
02 01-0 0 on-line 2376 0
02 01-0 1 on-line 2376 0
02 01-0 2 on-line 2376 0
02 01-0 3 on-line 2376 0
02 01-1 488 on-line 2376 0
02 01-1 489 on-line 2376 0
02 01-1 490 on-line 2376 0
02 01-1 491 on-line 2376 0
02 01-2 40 on-line 2376 0
02 01-2 41 on-line 2376 0
02 01-2 42 on-line 2376 0
02 01-2 43 on-line 2376 0
02 01-3 50 on-line 2376 0
02 01-3 51 on-line 2376 0
02 01-3 52 on-line 2376 0
02 01-3 53 on-line 2376 0
Memory:
-------
board perm base domain target deleted remaining
DID XSB mem MB mem MB address mem MB XSB mem MB mem MB
02 01-0 8192 2048 0x000003c000000000 32768
02 01-1 8192 0 0x0000020000000000 32768
02 01-2 8192 0 0x000001c000000000 32768
02 01-3 8192 0 0x0000018000000000 32768
IO Devices:
----------
DID XSB device resouce usage
02 01-0 sd0 /dev/dsk/c0t0d0s0 mounted filesystem "/"
02 01-0 sd0 /dev/dsk/c0t0d0s1 swap area
02 01-0 sd0 /dev/dsk/c0t0d0s1 dump device (swap)
To Next Page
Loading...
Need help?
General
