Chapter 2 Setting Up XSCF 2-133
3. Use the showdomainmode(8) command to confirm the secure mode is on. Also,
to apply the setting to the domain, restart the domain.
Enabling or Disabling the Automatic Boot Function
â– Command operation
1. Use the showdomainmode(8) command to specify automatic boot.
2. Use the setdomainmode(8) command to disable automatic boot.
<Example> Enable Host watchdog and Break signal suppression for domain ID 0.
XSCF> setdomainmode -d 0 -m secure=on
Diagnostic Level :max -> -
Secure Mode :off -> on
Autoboot :on -> -
CPU Mode :auto -> -
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :on (host watchdog: available Break-signal:non-receive)
Autoboot :on (autoboot:on)
CPU Mode :auto
XSCF> showdomainmode -d 0
Host-ID :0f010f10
Diagnostic Level :max
Secure Mode :on
Autoboot :on
CPU Mode :auto
<Example> Disable automatic boot for domain ID 0.
XSCF> setdomainmode -d 0 -m autoboot=off
Diagnostic Level :max -> -
Secure Mode :on -> -
Autoboot :on -> off
CPU Mode :auto -> -
The specified modes will be changed.
Continue? [y|n]:y
configured.
Diagnostic Level :max
Secure Mode :on (host watchdog: available Break-signal:non-receive)
Autoboot :off (autoboot:off)
CPU Mode :auto
To Next Page
Loading...
Need help?
General
