1A-65 Engine General Information and Diagnosis:
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Check the HO2 sensor coupler (1) for loose or poor
contacts.
If OK, then measure the HO2 sensor output voltage.
3) Insert the needle pointed probe to the HO2 sensor lead
wire coupler.
4) Warm up the engine enough.
5) Measure the HO2 sensor output voltage between B/Y
wire and B/Br wire, when idling condition.
6) Measure the HO2 sensor output voltage while holding
the engine speed at 3 000 r/min.
HO2 sensor output voltage at idle speed
0.3 V and less
(Positive terminal: B/Y – Negative terminal: B/Br)
HO2 sensor output voltage at 3 000 r/min
0.7 V and more
(Positive terminal: B/Y – Negative terminal: B/Br)
Special tool
(A): 09900–25008 (Multi-circuit tester set)
(B): 09900–25009 (Needle pointed probe set)
Tester knob indication
Voltage ( )
Is the voltage OK?
Go to Step 2. Replace the HO2
sensor with a new one.
1
I705H1110104-04
B/Br
B/Y
V
(A)
(B)
I705H1110107-04
To Next Page
Loading...
