Suzuki AN400 - Engine Stop Switch Inspection; Starter Button Inspection

Lighting Systems: 9B-10
Engine Stop Switch Inspection
B705H19206025
Inspect the engine stop switch in the following
procedures:
1) Remove the meter panel. Refer to “Meter Panel
Removal and Installation in Section 9D (Page9D-
14)”.
2) Disconnect the right handlebar switch coupler (1)
and (2).
3) Inspect the engine stop switch for continuity with the
tester. If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page6B-2)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the engine stop switch inspection,
reinstall the removed parts.
Starter Button Inspection
B705H19206026
Inspect the starter button in the following procedures:
1) Remove the meter panel. Refer to “Meter Panel
Removal and Installation in Section 9D (Page9D-
14)”.
2) Disconnect the right handlebar switch coupler (1)
and (2).
3) Inspect the starter button for continuity with the
tester. If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
“Handlebars Removal and Installation in Section 6B
(Page6B-2)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the starter button inspection, reinstall
the removed parts.
1
2
I705H1920032-01
Color
Position
RUN
O/B
O/W
OFF
I705H1920031-01
1
2
I705H1920032-01
PUSH
Color
Position
O/W Y/G
O/R
Y/W
I705H1920033-01