Automatic Transmission: 5A-9
Assembly
Refer to “Movable Drive Face Parts Inspection (Page5A-
9)”.
1) Assemble the rollers (1) to the movable drive face
(2).
NOTE
Check that the roller inside the movable drive
face is not running off the groove.
2) Assemble the damper (3) to the movable drive plate
(4).
3) Fill the grease into the sliding face of movable drive
face.
4) Apply the grease lightly on the oil seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
CAUTION
!
Excess grease should be wiped off.
5) Assemble the movable drive plate (4) to movable
drive face (2).
6) Assemble the movable drive face cover (5).
7) Assemble the spacer (6).
Movable Drive Face Parts Inspection
B705H15106007
Refer to “Movable Drive Face Disassembly and
Assembly (Page5A-8)”.
Inspect the following parts.
Movable Face
Inspect the movable face for any stepped wear on the
drive face. If any defects are found, replace the drive
face with a new one.
3
3
1
1
2
4
I705H1510021-06
I705H1510022-06
5
4
2
I705H1510023-04
6
I705H1510024-01
I705H1510026-01
To Next Page
Loading...
