5A-16 Automatic Transmission:
Clutch Shoe and Movable Driven Face Parts
Inspection
B705H15106010
Refer to “Clutch Shoe / Movable Driven Face
Disassembly and Assembly (Page5A-12)”.
Inspect the following parts.
Clutch Housing Inspection
Check for the following items and if any defects are
found, replace it with a new one.
• Existence of abnormal scratch.
• Measurement of clutch housing inside diameter.
Special tool
: 09900–20101 (Vernier calipers (1/15 mm,
150 mm))
Clutch housing inside “a”
Service limit: 160.5 mm (6.32 in)
Clutch Shoe Inspection
Check for the following items and if any abnormal
condition is found, replace the part with a new one.
• Play, damage, operation, etc. for the center area and
the centrifugal weight fulcrum.
• Existence of damage or oil sticking on the clutch shoe.
• Measure the thickness of clutch shoe center area by
using vernier calipers.
Special tool
: 09900–20101 (Vernier calipers (1/15 mm,
150 mm))
Thickness of clutch shoe “a”
Service limit: 2.0 mm (0.08 in)
Movable Driven Face Spring Inspection
Measure the free length of movable driven face spring
by using vernier calipers. If the measurement is below
the service limit, replace the spring with a new one.
Special tool
: 09900–20101 (Vernier calipers (1/15 mm, 150
mm))
Free length of movable driven face spring “a”
Service limit: 142.5 mm (5.61 in)
“a”
I705H1510065-03
I705H1510057-02
“a”
I705H1510058-03
“a”
I705H1510059-02
To Next Page
Loading...
