Suzuki AN400 - Rear Swingarm Dust Seal; Bearing Removal and Installation

Rear Suspension: 2C-8
Bearing
Inspect the play of the bearings by finger while they are
in the rear swingarm. Rotate the inner race by finger to
inspect for abnormal noise and smooth rotation. Replace
the bearing in the following procedures if there is
anything unusual. Refer to “Rear Swingarm Dust Seal /
Bearing Removal and Installation (Page2C-8)”.
Collar
Inspect the collar for wear or damage. If any defects are
found, replace it with a new one.
Rear Swingarm Dust Seal / Bearing Removal
and Installation
B705H12306026
Refer to “Rear Suspension Assembly Construction
(Page2C-2)”.
Removal
1) Remove the rear swingarm. Refer to “Rear
Swingarm Removal and Installation (Page2C-6)”.
2) Remove the dust seals (1) and (2) using the special
tool.
Special tool
(A): 09913–50121 (Oil seal remover)
3) Remove the bearing using the special tool.
Special tool
(B): 09913–70210 (Bearing installer set)
I649G1240015-01
I705H1230028-01
2
1
(A)
(A)
I705H1230029-02
(B)
I705H1230030-02