1J-9 Charging System:
7) After the electrolyte container is completely empty,
remove it from the battery and wait about 20
minutes.
8) Insert the caps (3) firmly into the filler holes, so that
the top of the caps do not protrude above the upper
surface of the top cover of the battery.
CAUTION
!
• Never use anything except the specified
battery.
• Once install the caps to the battery, do not
remove the caps.
• Do not tap the caps with a hammer when
installing them.
CORRECT
INCORRECT
Initial Changing
1) Measure the battery voltage using multi circuit tester.
2) The tester should indicate more than 12.5 – 12.6 V
(DC) as shown in the figure.
3) If the battery voltage is lower than the specification,
charge the battery with a battery charger. Refer to
“Battery Recharging (Page1J-10)”.
CAUTION
!
Do not remove the caps on the battery top
while charging.
NOTE
Initial charging for a new battery is
recommended if two years have elapsed
since the date of manufacture.
Battery Visual Inspection
B705H11A06008
Inspect the battery visual in the following procedures:
1) Visually inspect the surface of the battery container.
2) If any signs of cracking or electrolyte leakage from
the sides of the battery have occurred, replace the
battery with a new one.
3) If the battery terminals are found to be coated with
rust or an acidic white powdery substance, clean the
battery terminals with sandpaper.
3
I705H11A0025-03
I310G11A0026-01
I310G11A0027-01
I310G11A0028-01
To Next Page
Loading...
