Suzuki AN400 - Rear Suspension Mounting Bushing Removal and Installation

1D-54 Engine Mechanical:
• Install the oil seal using the special tool.
Special tool
(E): 09913–70210 (Bearing installer set)
CAUTION
!
Replace the removed oil seal with a new one.
Rear Suspension Mounting Bushing Removal
and Installation
B705H11406063
Removal
1) Separate the crankcase. Refer to “Engine Bottom
Side Disassembly (Page1D-37)” and “Engine
Bottom Side Assembly (Page1D-44)”.
2) Using appropriate size steel tubes (1) and vise,
remove the rear suspension mounting bushing (2)
(LH and RH).
Installation
1) Using an appropriate side steel tube and vise, press
in the busing into the crankcase (LH and RH).
CAUTION
!
Bushing end “A” must be flush with the
crankcase surface.
2) Assemble the crankcase. Refer to “Engine Bottom
Side Disassembly (Page1D-37)” and “Engine
Bottom Side Assembly (Page1D-44)”.
1. Steel tube 2. Bushing 3. Crank case
(E)
I705H1140158-02
I705H1140159-01
1
1
3
2
I705H1140160-01
1. Bushing 2. Crank case
I705H1140161-01
1
“A”
2
2
I705H1140162-05