6B-9 Steering / Handlebar:
• Install the front brake hose clamp (4).
CAUTION
!
Take care not to make air come in to the front
brake system.
• Perform the steering inspection after assembly has
been completed.
Steering Related Parts Inspection
B705H16206012
Refer to “Steering Removal and Installation (Page6B-6)”.
Inspect the removed parts for the following
abnormalities.
• Distortion of the steering stem
• Bearing wear or damage
• Abnormal bearing noise
• Race wear or damage
If any abnormal points are found, replace defective parts
with the new ones.
Steering System Inspection
B705H16206013
Refer to “Steering System Inspection in Section 0B
(Page0B-15)”.
Steering Stem Bearing Removal and Installation
B705H16206014
Refer to “Steering Components (Page6B-5)”.
Removal
1) Remove the steering stem. Refer to “Steering
Removal and Installation (Page6B-6)”.
2) Remove the dust seal (1) and steering stem upper
bearing (2).
3) Remove the steering stem lower bearing and inner
race using a chisel.
4) Remove the steering stem upper and lower bearing
races using the special tools.
Special tool
(A): 09941–54911 (Bearing outer race
remover)
(B): 09941–74911 (Steering bearing
installer)
4
I705H1620027-01
I705H1620028-02
I705H1620029-01
2
1
I705H1620030-02
I649G1620033-01
(B)
(A)
I649G1620034-02
To Next Page
Loading...
