Suzuki AN400 - Wiring Harness Routing Diagram

Wiring Systems: 9A-4
Wiring Harness Routing Diagram
B705H19102001
1
2
8
9
8
10
12
11
20
21
22
25
26
6
3
4
5
7
13
14
15
16
17
18
19
19
24
“E”
“D”
“C”
“B”
“A”
I705H1910905-04
1. Clamp
: Clamp the handlebar switch lead
wires (LH and RH), Brake hoses (Front
and Rear) and throttle cables.
12. Clamp
: Clamp the regulator/rectifier lead wire,
battery (+) and (–) lead wires.
23. Clamp
: Clamp the wiring harness, battery (–) lead wire
and generator lead wires.
2. Clamp
: Clamp with marking.
13. STVA 24. Ignition coil
3. Fuse box 14. STP sensor 25. Speed sensor
4. Key-less control unit (For 000 only) 15. TP sensor 26. Clamp
: Clamp the generator lead wires and HO2 sensor
lead wire with no slack.
5. ECM 16. ISC valve “A”: Cut the surplus of clamp.
6. White tape 17. Fuel injector “B”: Pass the lead wires through inside the cable guide.
7. Regulator/rectifier read wire 18. IAP sensor “C”: Pass the lead wires through outside the hoses.
8. Clamp
: Clamp the wiring harness and battery
(+) lead wire.
19. IAT sensor “D”: To IAT sensor.
9. Clamp
: Clamp the left and right handlebar
switch lead wires.
20. Clamp
: Clamp the wiring harness and battery
(–) lead wire.
“E”: Pass the ignition coil lead wire through inside the
water by-pass hose
10. Clamp
: Clamp the wiring harness, battery (+)
lead wire and starter relay lead wire.
21. Side-stand switch
11. Clamp
: Clamp the wiring harness and battery
(–) lead wire.
22. Clamp
: Clamp the wiring harness, battery (–)
and side-stand switch lead wire.