Engine Mechanical: 1D-57
Tightening Torque Specifications
B705H11407003
NOTE
The specified tightening torque is also described in the following.
“Camshaft and Sprocket Assembly Diagram (Page1D-1)”
“Engine Assembly Removal and Installation (Page1D-6)”
“Throttle Body Construction (Page1D-12)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Engine mounting nut 93 9.3 67.0 )(Page1D-8)
Cushion rod nut 85 8.5 61.5 )(Page1D-8)
Rear axle nut 120 12.0 87.0 )(Page1D-8)
Cylinder head bolt (L190) (Initial) 25 2.5 18.0 )(Page1D-19)
Cylinder head bolt (L130) 25 2.5 18.0 )(Page1D-19)
Cylinder head bolt (L190) (Final) 42 4.2 30.5 )(Page1D-19)
Camshaft journal holder bolt 10 1.0 0.7 )(Page1D-21)
Cam chain tension adjuster bolt 10 1.0 7.0 )(Page1D-21)
Spring holder bolt 23 2.3 16.5 )(Page1D-22)
Cylinder head cover bolt 14 1.4 10.0 )(Page1D-22)
Spark plug 11 1.1 8.0 )(Page1D-22)
Camshaft journal holder bolt 10 1.0 7.0 )(Page1D-23)
Oil gallery plug (cylinder head) 10 1.0 7.0 )(Page1D-26)
ECT sensor 12 1.2 8.5 )(Page1D-27)
Intake pipe bolt 10 1.0 7.0 )(Page1D-27)
Water inlet connector bolt 10 1.0 7.0 )(Page1D-33)
Oil pump mounting bolt 10 1.0 7.0 )(Page1D-44)
Crankcase bolt (M6) 11 1.1 8.0 )(Page1D-46)
Crankcase bolt (M8) 22 2.2 16.0 )(Page1D-46)
Balancer drive gear nut 150 15 11 )(Page1D-46)
Oil pump drive gear nut 23 2.3 16.5 )(Page1D-47)
Balancer driven gear nut 50 5.0 36.0 )(Page1D-47)
Cam chain tensioner bolt 23 2.3 16.5 )(Page1D-48)
Cam chain guide bolt 23 2.3 16.5 )(Page1D-48)
Generator rotor nut 160 16.0 115.5 )(Page1D-48)
Generator cover bolt 11 1.1 8.0 )(Page1D-49)
Speed Sensor 10 1.0 7.0 )(Page1D-49)
Oil filter cap bolt 10 1.0 7.0 )(Page1D-50)
To Next Page
Loading...
