Suzuki AN400 - Brake Caliper Piston Disassembly and Assembly

4C-7 Rear Brakes:
• Apply the brake fluid to piston seal (6) and dust seal
(7).
CAUTION
!
Replace the piston seal (6) and dust seal (7)
with the new ones.
BF: Brake fluid (DOT 4)
• Install the piston seals as shown in the figure.
• Set back the rear caliper piston (8) (back side) into the
caliper with turning clockwise.
• Apply silicone grease to inside of the boot and caliper
bracket pins and install them.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
Brake Caliper Piston Disassembly and
Assembly
B705H14306012
Refer to “Rear Brake Caliper Disassembly and
Assembly (Page4C-4)”.
Disassembly
1) Remove the snap ring (1).
CAUTION
!
Use caution when removing the snap ring as
the parts inside may fly out of position.
2) Remove the spring (2) and adjust nut (3).
7
6
I705H1430039-01
8
I705H1430022-01
I705H1430023-01
1
I705H1430024-01
2
3
I705H1430025-02