Suzuki AN400 - Page 371

Rear Brakes: 4C-6
• Apply silicone grease to the brake-lock shaft (3) and
O-ring (4).
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
CAUTION
!
Replace the O-ring with a new one.
• Install the brake-lock shaft (5) so as the punch mark
“A” may position between “B” of housing when
tightening (turning clockwise) the brake-lock shaft.
• Align the punch mark “C” on the brake-lock shaft with
the punch mark “D” on the brake-lock arm.
• Apply silicone grease to the tip and thread of brake-
lock adjuster, assemble the lock-nut and spring
temporarily.
: Grease 99000–25100 (SUZUKI Silicone
Grease or equivalent)
• Wash the bore and piston of the caliper with specified
brake fluid. Particularly wash the dust seal groove and
piston seal groove.
BF: Brake fluid (DOT 4)
CAUTION
!
• Wash the caliper components with fresh
brake fluid before reassembly. Never use
cleaning solvent or gasoline to wash them.
• Do not wipe the brake fluid off after
washing the components.
• When washing the components, use the
specified brake fluid. Never use different
types of fluid or cleaning solvent such as
gasoline, kerosine or the others.
3
4
I705H1430016-01
“B”
“B”
“A”
5
I705H1430018-01
“C”
“D”
I705H1430019-01
I705H1430020-01
I705H1430021-02
I649G1420012-01