Body Structure: 9E-4
Center Stand Removal and Installation
B705H19506018
Removal
1) Support the motorcycle using a jack.
CAUTION
!
Make sure that the motorcycle is supported securely.
2) Remove the center stand. Refer to “Center Stand Construction (Page9E-3)”.
Installation
Install the center stand. Refer to “Center Stand Construction (Page9E-3)”.
Specifications
Tightening Torque Specifications
B705H19507001
NOTE
The specified tightening torque is also described in the following.
“Body Frame Construction (Page9E-1)”
“Side-stand Construction (Page9E-2)”
“Center Stand Construction (Page9E-3)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
Special Tools and Equipment
Recommended Service Material
B705H19508001
NOTE
Required service material is also described in the following.
“Side-stand Construction (Page9E-2)”
“Center Stand Construction (Page9E-3)”
To Next Page
Loading...
