Suzuki AN400 - Clutch in; Stall Speed Inspection; V-Belt Type Continuously Variable Automatic Transmission Removal and Installation

Automatic Transmission: 5A-3
Clutch In / Stall Speed Inspection
B705H15106001
Refer to “Automatic Clutch Inspection in Section 0B
(Page0B-19)”.
V-belt Type Continuously Variable Automatic
Transmission Removal and Installation
B705H15106002
Removal
Clutch cover
1) Remove the side leg shield. Refer to “Side Leg
Shield Removal and Installation in Section 9D
(Page9D-15)”.
2) Remove the belt cooling duct (1) and outer clutch
cover (2).
3) Unfasten the clamp and remove the inner clutch
cover (3).
Movable drive face
1) Hold the fixed drive face using the special tools and
remove the fixed drive face nut and washer.
WARNING
!
• To prevent the fin from breakage or injury
from occurring due to inadvertent slipping,
engage the tool end with the side of pulley
securely and make sure the contact is on a
center area of the fin.
• Remove the drive face nut with pressing
the special tool to the drive face.
Special tool
(A): 09920–53740 (Clutch sleeve hub
holder)
(B): 09920–31020 (Extension handle)
2) Remove the fixed drive face (1).
3) Remove the V-belt (2) and remove the movable drive
face assembly (3) together with the spacer (4).
2
1
I705H1510002-01
3
I705H1510003-01
1
(A)
(B)
I705H1510004-02
2
3
4
I705H1510005-01