Suzuki AN400 - Specifications; Service Data; Tightening Torque Specifications

Automatic Transmission: 5A-17
Driven Face Inspection
Inspect the driven face surface for stepped wear. If any
defects are found, replace if with a new one.
Movable Driven Pin Inspection
Inspect the movable driven pin for abnormal wear or
damage. If any defects are noted, replace the pin with a
new one.
Specifications
Service Data
B705H15107002
Clutch
Unit: mm (in)
Transmission
Unit: mm (in) Except ratio
Tightening Torque Specifications
B705H15107003
NOTE
The specified tightening torque is also described in the following.
“Clutch Shoe / Movable Driven Face Components (Page5A-11)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
I705H1510060-01
I705H1510061-01
Item Standard Limit
Clutch wheel I.D. 160.0 – 160.2 (6.30 – 6.31) 160.5 (6.32)
Clutch shoe thickness 3.0 (0.12) 2.0 (0.08)
Item Specification Note
Primary reduction ratio 1.000 —
Reduction ratio 2.200 – 0.839
Secondary reduction ratio 2.214 —
Final reduction ratio 2.666 —
Drive V-belt width 25.1 (0.99) 24.1 (0.95)
Movable driven face spring free
length
150.0 (5.90) 142.5 (5.61)
Movable drive face roller O.D. 26.00 – 26.16 (1.024 – 1.030) —
Drive/driven face ware — 0.4 (0.02)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Clutch housing nut 85 8.5 61.5 )(Page5A-5)
Fixed drive face nut 105 10.5 76.0 )(Page5A-5)
Clutch shoe nut 105 10.5 76.0 )(Page5A-15)