Suzuki AN400 - Specifications; Service Data; Tightening Torque Specifications

Wheels and Tires: 2D-15
Specifications
Service Data
B705H12407002
Wheel
Unit: mm (in)
Tire
Tightening Torque Specifications
B705H12407003
NOTE
The specified tightening torque is also described in the following.
“Front Wheel Components (Page2D-2)”
“Front Wheel Assembly Construction (Page2D-3)”
“Rear Wheel Components (Page2D-8)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
Item Standard Limit
Wheel rim runout
Axial — 2.0 (0.08)
Radial — 2.0 (0.08)
Wheel axle runout
Front — 0.25 (0.01)
Rear — 0.25 (0.01)
Wheel rim size
Front 14 M/C x MT3.00 —
Rear 13 M/C x MT4.00 —
Item Standard Limit
Cold inflation tire
pressure
Solo riding
Front 175 kPa (1.75 kgf/cm
2
, 25 psi) —
Rear 200 kPa (2.00 kgf/cm
2
, 29 psi) —
Dual riding
Front 175 kPa (1.75 kgf/cm
2
, 25 psi) —
Rear 250 kPa (2.50 kgf/cm
2
, 36 psi) —
Tire size
Front 120/80-14M/C 58S —
Rear 150/70-13M/C 64S —
Tire type
Front BRIDGESTONE HOOP B03G —
Rear BRIDGESTONE HOOP B02G —
Tire tread depth (Recommended
depth)
Front — 1.6 mm (0.06 in)
Rear — 2.0 mm (0.08 in)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Front axle 65 6.5 47.0 )(Page2D-5)
Front brake caliper mounting bolt 35 3.5 25.5 )(Page2D-5)
Front axle pinch bolt 23 2.3 16.5 )(Page2D-5)
Rear swingarm mounting bolt 50 5.0 36.0 )(Page2D-10)
Rear wheel nut 120 12.0 87.0 )(Page2D-10)
Rear brake caliper mounting bolt 23 2.3 16.5 )(Page2D-10)
Exhaust pipe connecting bolt 23 2.3 16.5 )(Page2D-10)
Muffler mounting bolt 23 2.3 16.5 )(Page2D-10)