6B-11 Steering / Handlebar:
4) Do the same on the other grip end.
5) If the initial force read on the scale when the
handlebar starts turning is either to heavy or too
light, adjust it till it satisfies the specification.
a) First, loosen the front fork clamp bolts, lock-nut
and steering stem nut, and then adjust the
steering stem nut by loosening or tightening it.
b) Tighten the steering stem nut, lock-nut and front
fork clamp bolts to the specified torque and
recheck the initial force with the spring scale
according to the previously described
procedures.
c) If the initial force is found within the specified
range, adjustment has been completed.
NOTE
Hold the front fork legs, move them back and
forth and make sure that the steering is not
loose.
Specifications
Tightening Torque Specifications
B705H16207001
NOTE
The specified tightening torque is also described in the following.
“Handlebars Components (Page6B-1)”
“Steering Components (Page6B-5)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page0C-7)”.
I705H1620032-01
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Handlebar clamp bolt 23 2.3 16.5 )(Page6B-3)
Master cylinder bolt
10 1.0 7.0
)(Page6B-3) /
)(Page6B-4)
Steering stem nut 30 3.0 21.5 )(Page6B-7)
Lock-nut 30 3.0 21.5 )(Page6B-8)
Handlebar holder set bolt 23 2.3 16.5 )(Page6B-8)
Handlebar holder clamp bolt 55 5.5 40.0 )(Page6B-8)
To Next Page
Loading...
