Suzuki AN400 - Page 170

1D-26 Engine Mechanical:
6) Remove the oil seal (7) and spring seat (8).
CAUTION
!
Do not reuse the removed oil seal.
7) Remove the other valves in the same manner as
described previously.
8) Remove the thermostat case (9).
9) Remove the thermostat (10).
10) Remove the intake pipe (11).
11) Remove the ECT sensor (12).
12) Remove the oil jet (for cam chain tension adjuster)
(13).
13) Remove the oil gallery plug (cylinder head) (14).
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Tighten the oil gallery plug (cylinder head) (1) to the
specified torque.
Tightening torque
Oil gallery plug (cylinder head): 10 N·m (1.0 kgf-
m, 7.0 lb-ft)
CAUTION
!
Replace the gasket with a new one.
7
8
I705H1140050-02
9
I705H1140051-02
10
I705H1140053-01
11
13
12
I705H1140054-01
14
I705H1140055-01
1
I705H1140141-01