Engine Mechanical: 1D-45
Oil Sump Filter
Refer to “Oil Sump Filter Removal and Installation in
Section 1E (Page1E-4)”.
Balancer Shaft
• Install the balancer shaft (1).
NOTE
Bring the straightened part of the crank web
toward the balancer shaft.
Crankcase
• Install the O-rings (1) and (2).
• Install the dowel pins.
CAUTION
!
Replace the O-rings with the new ones.
• Clean and degrees the crankcase mating surfaces
(both surfaces) with a cleaning solvent.
• Apply bond to the right crankcase.
: Sealant 99000–31140 (SUZUKI BOND
No.1207B or equivalent)
CAUTION
!
• Coat the sealant evenly without break.
• Application of sealant must be performed
within a short period of time.
• Take extreme care not to let sealant enter
into the oil passages or bearings.
1
I705H1140171-01
1
2
I705H1140118-04
I705H1140227-01
To Next Page
Loading...
