Fuel System: 1G-11
2) After removing the clamp screw (1), ground wire (2)
and lead wire (Bl) (3), remove the fuel pump
assembly (4).
3) Detach the fuel mesh filter (5) and remove the fuel
pump (6).
4) Disconnect the lead wire (gray) (7) and remove the
fuel level gauge assembly (8).
5) Remove the fuel guide (9) and fuel pressure
regulator (10).
Assembly
Refer to “Fuel Mesh Filter Inspection (Page1G-13)”.
Assemble the fuel pump assembly in the reverse order
of the disassembly. Pay attention to the following points:
CAUTION
!
• To prevent fuel leakage, each O-ring must
be replaced with a new one.
• Apply engine oil lightly to each of the O-
rings.
• Connect all wiring couplers securely so as not to
cause contact failure.
• With the engine oil lightly applied to the O-ring, install
the fuel pump to the fuel tank.
• After the fuel pump mounting bolts have been
tightened temporarily, tighten them to specification in
the specified torque.
Tightening torque
Fuel pump mounting bolt: 10 N·m (1.0 kgf-m, 7.0
lb-ft)
4
2
1
3
I705H1170016-02
5
6
I705H1170017-02
7
8
I705H1170018-02
9
10
I705H1170019-02
I705H1170021-02
I705H1170022-01
To Next Page
Loading...
