10-28 ELECTRICAL SYSTEM
• Remove the fuel gauge
1 from the fuel pump.
• Install the fuel gauge.
• Install the fuel pump. (7-11)
FUEL PUMP RELAY
• Remove the fuel pump relay. (10-4)
Same as side-stand relay. (10-17)
OIL PRESSURE INDICATOR
NOTE:
Before inspecting the oil pressure switch, check the engine oil
level.
• Remove the leg side cover. (9-12)
• Disconnect the oil pressure switch lead wire from the oil pres-
sure switch.
• Turn the ignition switch “ON” position.
Check if the oil pressure indicator comes on, when grounding
the lead wire. If the oil pressure indicator does not come on,
check the circuit connection or replace the bulb.
To oil pressure
switch
To Next Page
Loading...
