Engine General Information and Diagnosis: 1A-58
P1750-L (Use of SDS)
Step Action Yes No
1 1) Click the data monitor button (1).
2) Check the manifold absolute pressure 2 data.
Approx. 0 kPa (0 kgf/cm
3
, 0 psi) and less OK?
Go to Step 2. Go to Step 4.
2 1) Turn the ignition switch OFF.
2) Check the IAP sensor coupler for loose or poor contacts.
If OK, then check the IAP sensor lead wire continuity.
3) Disconnect the IAP sensor coupler.
4) Insert the needle pointed probes to the lead wire coupler.
Go to Step 3. R and G/B wire open,
W/Bl wire shorted to the
ground.
1
I718H1110251-01
I718H1110183-02
I717H1110013-02
To Next Page
Loading...
