Suzuki GSF650A - Rear Wheel Speed Sensor Routing Diagram

4E-11 ABS:
Rear Wheel Speed Sensor Routing Diagram
B817H24502004
7: Clamp
: Clamp the sensor lead wire at the white marking.
“H”: Clamp the sensor lead wire on the protector of brake hose.
8. Front wheel speed sensor “I”: Clamp the sensor lead wire at front side of the brake hose.
1
2
2
2
3
“A”
“D”
“E”
“F”
“G”
4
“a”
“C”
“B”
2
I717H2450008-01
1. Rear wheel speed sensor “C”: Clamp sensor lead wire with white tape matched green paint of brake hose.
2. Brake hose No.2 “D”: Pass through the sensor lead wire inside of the brake hose guide.
3. Brake hose No.1 “E”: Pass through the sensor lead wire on the brake hose.
4. Brake hose guide “F”: Clamp the sensor lead wire upper side of brake hose.
“A”: Outside mark “G”: Pass through the sensor lead wire inside of the brake hose.
“B”: After the clamp has contacted to the stopper, tighten the bolt. “a”: 35 mm (1.4 in)