Suzuki GSF650A - Oil Pump Inspection; Specifications; Service Data; Tightening Torque Specifications

Engine Lubrication System: 1E-12
• Pass the chain between the oil pump drive and driven
sprockets.
• Install the spacer (8).
• Reinstall the clutch. Refer to “Clutch Installation in
Section 5C (Page 5C-14)”.
Oil Pump Inspection
B817H21506011
Inspect the oil pump in the following procedures:
1) Remove the oil pump. Refer to “Oil Pump Removal
and Installation (Page 1E-10)”.
2) Rotate the oil pump by hand and check that it moves
smoothly. If it does not move smoothly, replace the
oil pump assembly.
CAUTION
!
Do not attempt to disassemble the oil pump
assembly.
The oil pump is available only as an
assembly.
3) Install the oil pump. Refer to “Oil Pump Removal and
Installation (Page 1E-10)”.
Specifications
Service Data
B817H21507001
Oil Pump
Oil
Tightening Torque Specifications
B817H21507002
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
7
8
“C”
I718H1150062-01
I718H1150063-01
Item Standard Limit
Oil pressure (at 60 °C, 140 °F)
100 – 400 kPa
(1.0 – 4.0 kgf/cm
2
, 14 – 57 psi)
at 3 000 r/min
—
Item Specification Note
Engine oil type SAE 10W-40, API SF/SG or SH/SJ with JASO MA
Engine oil capacity
Change 3 000 ml (3.2/2.6 US/lmp qt)
Filter change 3 500 ml (3.7/3.1 US/lmp qt)
Overhaul 3 700 ml (3.9/3.3 US/lmp qt)
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Main Oil gallery plug (M16) 35 3.5 25.5 )(Page 1E-4)
Oil gallery plug (M12) 15 1.5 11.0 )(Page 1E-5)
Oil pressure switch 14 1.4 10.0 )(Page 1E-7)
Oil pressure switch lead wire bolt 1.5 0.15 1.1 )(Page 1E-7)
Piston cooling oil jet bolt 10 1.0 7.0 )(Page 1E-9)
Oil gallery jet 22 2.2 16.0 )(Page 1E-9)
Oil pump mounting bolt 10 1.0 7.0 )(Page 1E-11)