1B-6 Emission Control Devices:
Heated Oxygen Sensor (HO2S) Inspection
B817H21206002
Refer to “DTC “C44” (P0130/P0135): HO2 Sensor
(HO2S) Circuit Malfunction in Section 1A (Page 1A-
104)”.
PAIR Reed Valve Removal and Installation
B817H21206003
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
2) Drain engine coolant and remove the thermostat
connector. Refer to “Thermostat Connector /
Thermostat Removal and Installation in Section 1F
(Page 1F-9)”.
3) Disconnect the hoses (1) and remove the PAIR reed
valve covers (2).
4) Remove the PAIR reed valves (3).
Installation
Install the PAIR reed valve in the reverse order of
removal. Pay attention to the following points:
• Install the PAIR reed valves (1) as shown.
• Apply thread lock to the bolts and tighten them to the
special torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
PAIR reed valve cover bolt (a): 11 N·m (1.1 kgf-m,
8.0 lbf-ft)
PAIR Control Solenoid Valve Removal and
Installation
B817H21206004
Removal
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
2) Remove the upper panel. Refer to “Exterior Parts
Removal and Installation (GSF650/S/A/SAK7) in
Section 9D (Page 9D-6)”.
3) Disconnect the PAIR control solenoid valve coupler
(1) and PAIR hoses (2).
4) Remove the PAIR control solenoid valve (3).
Installation
Install the PAIR control solenoid valve in the reverse
order of removal. Pay attention to the following point:
• Connect the PAIR control solenoid valve coupler and
PAIR hoses securely. Refer to “PAIR System Hose
Routing Diagram (Page 1B-4)”.
1
1
2
2
I718H1120023-01
3
3
I718H1120029-01
1
(a)
(a)
I717H1120014-03
1
2
2
3
I717H1120005-01
To Next Page
Loading...
