1G-14 Fuel System:
Assembly
Refer to “Fuel Mesh Filter Inspection and Cleaning
(Page 1G-14)”.
Assemble the fuel tank pump in the reverse order of the
disassembly. Pay attention to the following points:
CAUTION
!
• To prevent fuel leakage, each O-ring must
be replaced with a new one.
• Apply engine oil lightly to each of the O-
rings.
• Connect all wiring couplers securely so as not to
cause contact failure.
Fuel Mesh Filter Inspection and Cleaning
B817H21706015
Inspect the fuel mesh filter in the following procedures:
1) Remove the fuel mesh filter. Refer to “Fuel Pump
Disassembly and Assembly (Page 1G-12)”.
2) If the fuel mesh filter is clogged with foreign particles,
it hinders smooth gasoline flow resulting in loss of
engine power. Such a filter should be cleaned by
blowing with compressed air.
NOTE
When the fuel mesh filter is dirtied
excessively, replace the fuel filter cartridge
with a new one.
3) After finishing the fuel mesh filter inspection, reinstall
the fuel mesh filter. Refer to “Fuel Pump
Disassembly and Assembly (Page 1G-12)”.
Fuel Hose Inspection
B817H21706016
Refer to “Fuel Line Inspection in Section 0B (Page 0B-
12)”.
Fuel Injector / Fuel Delivery Pipe / T-joint
Removal and Installation
B817H21706017
Refer to “Throttle Body Disassembly and Assembly in
Section 1D (Page 1D-11)”.
1. Fuel pump (+) lead wire (BI)
2. Fuel level thermistor lead wire (W)
3. Fuel level gauge (+) lead wire (BI)
4. Fuel pump (–) lead wire (B)
5. Fuel level gauge (–) lead wire (B)
I717H1170017-01
I718H1170039-01
1
2
3
4
5
I718H1170037-01
I718H1170003-01
To Next Page
Loading...
