Manual Transmission: 5B-19
• Install the bearings with the special tool.
NOTE
The stamped mark side of gearshift shaft
bearing faces outside.
Special tool
(A): 09913–70210 (Bearing installer set)
• Install the oil seal with the special tool.
Special tool
(A): 09913–70210 (Bearing installer set)
• Apply grease to the oil seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
Specifications
Service Data
B817H25207001
Transmission + Drive Chain
Unit: mm (in) Except ratio
(A)
(A)
I718H1520066-01
(A)
I718H1520067-01
Item Standard Limit
Primary reduction ratio 1.700 (85/50) —
Final reduction ratio 3.200 (48/15) —
Gear ratios
Low 3.076 (40/13) —
2nd 2.058 (35/17) —
3rd 1.600 (32/20) —
4th 1.363 (30/22) —
5th 1.208 (29/24) —
Top 1.107 (31/28) —
Gearshift-fork to gearshift-fork
groove clearance
No.1, No.2 &
No.3
0.1 – 0.3 (0.004 – 0.012) 0.50 (0.020)
Gearshift fork groove width
No.1, No.2 &
No.3
5.0 – 5.1 (0.197 – 0.201) —
Gearshift fork thickness
No.1, No.2 &
No.3
4.8 – 4.9 (0.189 – 0.193) —
Gearshift lever height 45 – 55 (1.8 – 2.2) —
To Next Page
Loading...
