Suzuki GSF650A - Specifications; Service Data; Tightening Torque Specifications

5C-19 Clutch:
Specifications
Service Data
B817H25307001
Clutch
Unit: mm (in)
Tightening Torque Specifications
B817H25307002
NOTE
The specified tightening torque is also described in the following.
“Clutch Hose Routing Diagram (Page 5C-2)”
“Clutch Control System Components (Page 5C-6)”
“Clutch Components (Page 5C-12)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List in Section 0C
(Page 0C-7)”.
Item Standard Limit
Clutch drive plate thickness No.1, 2, 3 2.92 – 3.08 (0.115 – 0.121) 2.62 (0.103)
Clutch drive plate claw width No.1, 2, 3 13.7 – 13.8 (0.539 – 0.543) 13.0 (0.51)
Clutch driven plate distortion — 0.10 (0.004)
Clutch spring free length 54.15 (2.13) 51.5 (2.0)
Clutch master cylinder bore 14.000 – 14.043 (0.5511 – 0.5529) —
Clutch master cylinder piston diam 13.957 – 13.984 (0.5495 – 0.5506) —
Clutch release cylinder bore 38.18 – 38.23 (1.503 – 1.505) —
Clutch release cylinder piston diam 38.08 – 38.13 (1.500 – 1.501) —
Clutch fluid type Brake fluid DOT 4 —
Fastening part
Tightening torque
Note
N⋅mkgf-mlbf-ft
Air bleeder valve (Clutch)
6 0.6 4.5
)(Page 5C-4) /
)(Page 5C-5)
Clutch master cylinder holder bolt 10 1.0 7.0 )(Page 5C-7)
Clutch hose union bolt 23 2.3 16.5 )(Page 5C-7)
Clutch lever pivot bolt 6 0.6 4.5 )(Page 5C-9)
Clutch lever pivot bolt lock-nut 6 0.6 4.5 )(Page 5C-9)
Clutch sleeve hub nut 150 15.0 108.5 )(Page 5C-15)
Clutch spring set bolt 10 1.0 7.0 )(Page 5C-16)