Front Suspension: 2B-9
Front fork cap bolt
• Apply fork oil lightly to the O-ring (1).
CAUTION
!
Use a new O-ring (1) to prevent oil leakage.
: Fork Oil 99000–99044–10G (SUZUKI FORK
OIL G-10 or equivalent)
• Install the front fork cap bolt to the inner tube
temporarily.
• Install the front fork protector (2).
NOTE
Fit the projection of the front fork protector to
the depression of the front fork outer tube.
Front Fork Inspection
B817H22206004
Refer to “Front Fork Inspection in Section 0B (Page 0B-
21)”.
Front Fork Parts Inspection
B817H22206005
Refer to “Front Fork Disassembly and Assembly
(Page 2B-3)”.
Inner and Outer Tubes
Inspect the inner tube sliding surface and outer tube
sliding surface for scuffing.
Fork Spring
Measure the fork spring free length. If it is shorter than
the service limit, replace it with a new one.
Front fork spring free length
Service limit: 368 mm (14.5 in.)
Cylinder / cylinder ring
Inspect the cylinder (1) and cylinder ring (2) for wear or
damage. If any defects are found, replace the cylinder or
cylinder ring with a new one.
1
I717H1220032-01
2
I717H1220033-01
I649G1220035-03
I717H1220034-01
1
2
I717H1220035-01
To Next Page
Loading...
